Precautions For Building Computers

Use lots of overhead light. Once you have all the parts together, find a flat, smooth, clean, static-free surface. Make sure your clothes are not polyester or you stand a chance of building up buttloads of static and having a merciless discharge turning your junk into… well… junk.

I like using Gatorade lids to hold my screws and small parts in. Yeah Trailer Park Boys-ish, I know, but it works. Working above tile is good, also, so you can hear the small parts when they drop and kinda locate them easier by where the sound comes from. With the tower open and all parts scattered on the table, lower the motherboard in. Take small pin nails and set them through the mounting holes to mark your spot — should take like 6-9 of them depending on board size and tower abilities. Pull motherboard back out and try to not disturb the pin nails. Replace each nail with mounting studs, lower board in, and screw it down. Follow instructions in the manuals for motherboard and instructions from tower to set up power switches and USB connectors. you may sometimes need to split the end connector for the tower speaker so it fits the prongs. Tie back wires so they stay low and out of view.

Insert RAM, CPU, and heat sink. Simply put: Be gentle, be slow, bend no prongs, and scratch no boards

Set in all drives: CD-ROM / DVD / hard drive / floppy drive. Place the power supply in, and take the board connecting the wire strand and try and map the cleanest, least visible route. Then plug it in. Do not crack the motherboard (yes, it can happen)! Do the same with the drives. I tie them to the rack as I go down the line. Keep hard drives away from all magnets — even the case speaker magnet!

The Video card is done pretty much the same way as the RAM. The slit(s) in the card tells you which way it should face.

Get a good look at the inner case. All air paths need to be clear of anything — even wires. Now plan the path your air will flow and then look at your fans to see which direction the blades should face to achieve the airflow you planned.

Close the case, cross toes, plug in all devices for first boot, and press power button. Pray for BIOS/CMOS boot. Press delete and watch temperatures for about ten minutes or until you see that it is getting really hot.

More stuff to keep in mind.