Canon Image Prograph 710. Prints a nice fine colorful line, Excellent for design in computer aided drafting.
It seems the printhead has an exact life predetermined. As if there is an exact number of prints it is allowed before you have to pay your plotter dues. What I mean is, this head goes out pretty often. about once every two years where I work.
Today I got the fine duty of removing and replacing this printhead.
So I took pictures along the way and decided I would post a “How to” for those who might want to see the process.
Fairly simple printhead to replace.
Before anything, on eyour Image Prograph 710 (ipf710) go to the menu, and go to maintenance.
1. Select the option that says “replace printhead”.
The plotter will make a few sounds and put up a warning on the screen saying it is busy.
What plotter is doing, is evacuating all of the ink in the printhead so you don’t make a mess and or mess up the plotter with an ink spill.
This took about 3-5 minutes.
2. When the plotter has completed dumping the ink out of the printhead, you should hear some beeps and the screen will now tell you to unlock and lift the large front cover.
3. The printhead carriage will now be in the center (or close enough that you can access the printhead) and the screen should be prompting you to open the carriage cover. Do that, it lifts from the front to the back. It’s about 3″x5 “.
carriage cover
4. Inside you will there is another locking mechanism, likely the same color. Lift that one also, it should lift from back to the front. More like a locking arm.
Arm Lock
5.You should then find yet another locking mechanism, likely the same color, it should lift from front to back.
When you lift this one, you should feel a click, that’s the printhead being released and slightly pushed up and outward. No more than an 8th of an inch though.
Last Lock
6. Now is a good time to put on a glove. There may be some ink. Ours was quite clean. Now reach in and grip the printhead tight and pull upward. Should not need much force. Be careful. Many breakable parts in this area that can cost you plenty of downtime.
PF-03 printhead
This is what it looks like from the side Look at the image closely and look at the image above for orientation.
Put the old printhead in a bag for recycling. Or save it.
7. Now unbox and unbag the new print head and take the safety covers off.
-
- Boxed New Printhead
-
- Sealed in bag printhead
-
- Protective caps
Now just reverse what you just did, but with new printhead.
Once everything is back together, the printer will fill the new printhead with ink and begin testing and calibrating. This takes several minutes 10-15 minutes.
-
- Refilling the printhead
-
- Calibrating
-
- Calibration results
Once the calibration is complete, check the printout for anything that looks jagged or like ink blobs. If anything looks out of the ordinary, you may want to run to the menu and see if you can calibrate it again, or run the head cleaner mode.
Mine was fine so I walked around the office with the calibration results telling everyone I have created a bar graph but couldn’t remember what it was for.
Just to see their frustration about wasted time and ink.
If you came here for drivers or manuals and made it this far, Here’s a link .
. Server Driver spoiling, is not an option , finds drivers on the server and installs them. Be sure and install the drivers. Twain untested as of yet. Scanner issues will come.
